Instruction
Auovo Auto Cup Holder Inserts Coaster Fit for 2020-2023 Gladiator JT
Thank you for Purchasing our product! If you have any question about this item, such as missing pieces/ receive wrong item/ doesn't fit/ don't know where the liners go etc. , please feel free to email us by support@auovo.com.
LINER FOR THE WIRELESS PHONE CHARGING AREA:
Please note that some of our kits have liners that fit for the wireless charging areas. For the safety, please temporarily remove them while charging your phone. Leaving the Liners in place while charging your phone may cause damage to the liners and it may ineffective charging due to the added thickness of the mat.
1. Clean Before installing
*To get the liners to stay in place, the pockets must be clean before installation.
2. Installing
Follow the installation guide to put the liners to corresponding pockets.
*Some set of liners with a number and L / R for easy installation, “L”=left,“R”=Right.*
*Some liner come with double side tape* You can use them to the liners you need, such as the rear seat fold-able cup holders pieces.
3. Post Install Cleaning
The inserts Liners collect and hold condensation from your bottles, cans or drinks, prevent your cup holders from getting wet, sticky, gooey. Easy to remove it to clean with water.
Shake the dust and crumbs off the liners. Wash them with warm water if needed, then put them in the clean place let them dry naturally.
***Missing pieces? Receive Wrong item? ***
Please contact us : ) by email support@auovo.com
***Extra pieces？***
We include extra pieces to fit all trim levels of the car, it is very possible you have extra pieces.
***Curled Mats? ***
During shipping, some liners may get slightly bent and not sit flat in the compartments. Usually, it will fix themselves over 1-2 weeks by being in a hot car. If you are in a cold climate you may need to use a hair dryer, wash the mat with warm water, or place them on your dashboard in the sun to fix the curling.
- 【Auto 3D Cup Holder Inserts Coaster】 Car Cup Holder Insert/Coasters Center Console Mats fit for 2020 2021 2022 2023 2024 Gladiator JT Accessories.
- 【MADE OF SILICONE】Washable. All-Weather Protection. Thickness: 0.07 inch. RAISED EDGE, High of Coaster: 0.28 inch. The gap will not block the light in the cup holder.
- 【PULL-TAB and RAISED EDGE】1. Small pull-tab, easy to install and remove to clean. 2. Raised lip edge, like a wall to hold the water splashed from the cup and prevent it from spilling on the original cup holder.
- 【EASY TO USE】 – Just Put It In. Make better use of the Cup Holders , when it became dirty, you can use the handle on the mat to take it out.
- 【NOTE!!! 】PLEASE PAY ATTENTION TO THE SHAPE OF BACK SEAT FLOOR CUP HOLDERS. This set of cup holder coasters ONLY FIT FOR DEEP REAR CUP HOLDERS AS SHOWN IN THE PHOTOS. They MAY NOT FIT IN SOME TRIMS. Please see the listing photos carefully before purchasing.